Battery air pump replacement

Toyota Rav4 EV Forum

Help Support Toyota Rav4 EV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

asavage

Well-known member
Supporting Member
Joined
Aug 7, 2017
Messages
834
Location
Oak Harbor, Wash.
The RAV4 EV, the Mercedes Electric Drive/B250e, and the electric Smart cars, they all have a desiccant pack in the battery.

The RAV4 EVs have some kind of little air pump on top of the battery cover, it's under the driver seat area, and it's quite noisy. It's one of the loudest things you hear when you plug in to charge. You think you're hearing coolant pumps, but you're usually hearing that air pump.

The last few months, mine has been getting noticeably louder.

Is there any information on repairing/replacing this pump?

I believe I read somewhere in the past where somebody cut a hole in the floor of the car to access the pump for repair, rather than dropping the battery!

Jimbo69NY has a YT video on the pack, and pointed out the thing.



1715022770889.png
1715022793042.png
 
On my car it runs noisily after the car has been driven in rain or humid weather, then goes silent when things dry out. I don't know if it only runs if a sensor says it is necessary (so only on or off), or if there is a variable speed.
 
Mine always buzzed when first plugged in to charge, in any weather. Now, it's silent; I can hear a coolant pump, and sometimes the radiator fan comes on/off, on low speed, which I only notice if I happen to be in the driveway working on something else when it happens.
 
Nope. That's a private FB group and I've never seen a single post there.
Hmm OK. So far, I have found the following discussions regarding the 2012-2014 RAV4 EV battery dehumidifier:
  • asavage in this thread,
  • Xuye Li in this post on Facebook by (as mentioned in my previous post; not accessible for some bc private group),
  • James Klafehn on Youtube (here and here) and asking around in this thread (diyelectriccar.com),
  • Samli on this forum here (maybe that's the one you were referring to?)
I'm trying to figure out if an aftermarket dehumidifier can be made for EV batteries in general (not for a specific make/model) because it seems that a large fraction of EV battery failures is related to moisture ingress. For example, count these cases, accross many makes and models, on youtube.com/@CarRepairVideos. The RAV4 EV is one of the few EV models (that I know of) that has both desiccant and desiccant regeneration capabilties. The dehumidifier won't solve most of the consequences of things like leaks of course, but it can remove water vapor from the battery "breathing in" vapor as a consequence of altitude (pressure) and ambient temperature changes.
 
IMG_8991.jpgIMG_8992.jpgIMG_8993.jpgIMG_8994.jpgIMG_8995.jpgIMG_8997.jpgIMG_8998.jpgIMG_8999.jpg IMG_9001.jpg IMG_9002.jpg

For the search engines: Okenseiko P54E01R, motor stamped N24225.

Mabuchi Motors bought Okenseiko around Dec2022. Okenseiko specialized in pumps for vacuum, air, and liquids and have been used in medical devices, MB seat lumbar supports, and bidet pumps. The P54E-0012RG (presumed to be similar; it's both brushless and the same 27mm dia.) "datasheet" lists 12v but not inputs, and this is a three-wire device. That complicates unit testing. Some P54s have brushes, some are brushless.

The P54E-0012RG, which is called a "high durability" model, is rated for 3000 hours service life, with 2000 hours "guaranteed". 3k hours is . . . not a lot.

The heater plate is positioned (suspended) to be nearly in the middle of what I presume to be silica beads (desiccant). I'm not seeing any controller logic on that PCB; I assume the BMS has a schedule or triggers, and then sends 12v to this collection of parts, which then runs blind. I don't see a humidity sensor. The beads have worn off the markings on what looks like it may be a thermostat in series with a fuse on the heater plate.

This is a model of the P54 line which has both inlet and outlet hose nipples, so it's harder to source. It can apparently be had for under $200 from one source*, and for well over $320 from another (NLA).

[I later ordered one @ USD$195 after "processing fee", about two weeks lead was promised, and the next day they wanted to raise the price to about $400. I canceled the order.]
 
Last edited:
P54E01R_01b.pngair_03_01.gif

Now you know the source of that buzzing noise when charging.

IMG_9003.jpgIMG_9004.jpg

The pump apparently pulls air from the desiccant chamber, and pushes it out this brass hose barb.


IMG_9005.jpg

Nice high-temp RTV here . . .


IMG_9006.jpg

The pump comes apart easily, once you score the paper tag. On mine, the rotor's upper plain bearing (bronze-colored) is shot and the rotor moves almost 1/8" (3mm), so it binds on the stator I assume. It does not turn when I tried using my fingers.
IMG_9007.jpgIMG_9008.jpg
 
Last edited:
The supplier I'd ordered the pump from tried to more than double the price, after I'd paid for it.

Screenshot from 2024-09-06 16-19-31.png

So, I'm still looking for one.

I filed off the four crimped areas at the rear of the motor, pulled off the driver from the load end, desoldered the three coil wires (two of them broke) using copper braid and new flux, and instead of finding the load end bearing worn out, the shaft has much of the wear instead. Normally, in a plain bearing, you engineer a softer fixed bearing material to be mated with a harder rotating/moving part, but not here.

IMG_9059.jpg IMG_9060.jpg IMG_9061.jpg IMG_9062.jpg IMG_9063.jpg IMG_9064.jpg

I'm not thinking of a way to rescue this one. And I'm not finding any brushless examples of Oken Seiko air pumps, either, outside of their model listing. Plenty of 2-wire, none with this six-pin connector.
 
Last edited:
I received a pump today:

IMG_9306.jpg IMG_9307.jpg

I'd ordered one pump each from two different suppliers in China . . . and I cannot determine which order this is.

There is no packing slip or indication of origin on or inside the packaging. The shipping envelope it arrived in is UPS, and that has a tracking number with a history to Shanghai on 25Sep, but no indication as to who shipped it [shrug].

Perhaps, if/when the second pump arrives, that vendor will give me a clue as to who sent that one.

I suspect that this one's origin is the first vendor (the one that doubled the price after they'd already charged my credit card), about $400 (they did refund my initial order, before I later re-ordered it at the higher price). Their website order status is currently, "Prepared for shipment, 21Sep".

The other one is probably the one I ordered ten days later, at a cost of around $280, whose website has no information on the order at all, aside from "Paid". They have not replied to an inquiry about obtaining a tracking number.

---
[next day]
Two emails this morning (the Chinese week-long holiday is over.

1) Order canceled for this one:
Chinahao.com said:
Dear user:Hello, we are very sorry that the order cannot be executed due to the current problem of the company's warehouse system. At present, the order has been cancelled and fully refunded. Please pay attention to your credit card refund information.It is expected to be able to operate normally after October 20, 2024.
It took them 30 days to cancel the order.

2) Order "has been sent" for this one:
yoycart.com said:
Dear Alan Savage:
Your yoycart.com order : #10207372
link:http://www.yoycart.com/User/orderdetails?id=10207372
Status:preparedforshipment
weight:500g
Product Money:$358.79
Shipment Money:$23.80
Sub Total:$382.59
Have New Message,please Login to http://www.yoycart.com for View:
Thank you for your order.
Your order has been sent by UPS on 2024-10-09.And the transit time is 7-25 days. please be patient.
If you need instant help please e-mail us at : [email protected]
You can track the status of your order here: https://www.ups.com/cn/en/Home.page
shipment number: 1ZHF98590303988648
The tracking number matches the one on the over-envelope I received yesterday, so . . . mystery solved, though "has been sent" must mean "has been delivered". yoycart.com has lousy communication, and doubled the price after ordering but a) did refund my credit card when I cancelled the first order, and b) did actually, eventually, ship me an air pump.

There was a foreign transaction fee charged by my bank for using the credit card for yoycart's web payment processor, so the final cost was close to $400.
 
Last edited:
Back
Top